Earthworks 521 Microphone Preamplifier (500 Series)

$1,249.00 $999.00
(You save $250.00)
Write a Review
SKU:
Earthworks-521
UPC:
827517000000
Condition:
New
Availability:
Special Order (Expect Availability in 7-10 Business Days -- Perhaps Less!)
Shipping:
Free Shipping
Earthworks 521 Microphone Preamplifier (500 Series)

EARTHWORKS 521 

500 Series Zero Distortion Technology™ Preamplifier

Based on the Earthworks ZDT Zero Distortion Preamplifiers™ technology designed by David Blackmer, the 521 brings the exacting standards of the Earthworks Zero Distortion Technology preamplifiers to the convenient 500 series format.

The solid state 521 features switchable phantom power, polarity invert, and peak amplitude clip detection, just as in the original 1021 single channel ZDT Preamp. The transformerless output stage of 521 ZDT easily drive long cable runs without loss of quality, making it ideal for long cable runs. Transparent gain is switchable from 5dB to 60dB in 5dB steps.

The Earthworks microphone preamplifier topology provides outstanding common mode rejection, excellent overload margin and an incredibly low noise floor, combined with the ultra wide bandwidth of the ZDT Preamps and distortion of less than 1 part per million. This exceptional level of performance is maintained over an extensive range of impedances applied to the input making the 521 suitable for practically any microphone – ribbon, dynamic or condenser.

  • Zero Distortion – less than one part per million

  • Solid-state, transformerless

  • Switchable 48V phantom power

  • Polarity invert switch

  • Peak amplitude clip detection

  • Transparent gain switchable from 5dB to 60dB in 5dB steps

  • Ultra-low noise floor

  • Ultra-wide bandwidth

  • Suitable for most ribbon, dynamic or condenser microphones

     

Preamp Type: Solid State

Number of Channels: 1

Frequency Response: 2Hz to 100kHz ±0.1dB, 1Hz to 200kHz ±0.5dB

Impulse Response: 1.4µs

Distortion: XLR out: less than 1ppm (0.0001%); 1/4” out: 0.001%

Input Noise: 1.6nVHz½ at 20dB gain; 0.6nV/Hz½ at 60dB gain

EIN: -132dBV at 20dB gain; -143dBV at 60dB gain

Slew Rate: 22V/µs

Output DC Offset: ±1 mV typical, servo balanced

Input / Output Connector: 500 Series EDAC Edge connector

XLR Input Impedance: 10KΩ phantom on, 100KΩ phantom off

Front Panel Balanced Out: ¼” TRS XLR Fem. balanced transformerless (variable)

Dimensions: 1 500 series rack space 1.5” x 5.25” x 6”

Weight: 0.8 lb. (0.36kg)